Dimensions: 90cm (35") in length, 5mm (3/8") wide, 1mm high
Voltage: 12 VDC (24VDC available), Current: less than 83mA
Trimmable every 3 LEDs (every 2 1/2")
Requires no inverter (no RF interference)
Easy to install - double sided tape already applied for fast set-up
Dimmable using electronic PWM dimmers or rheostats (see below)
Floods the instrument panel with an even lighting source
Ideal for Experimental Aircraft, RVs, Boats, and Specialty Vehicles
New Pilot's Light Dimmer, Part # 12V-Dimmer01 (Available July 10, 2008)
1.5A (18W) 12V dimmer using PWM (pulse wave modulation) for precise control
Integrated on/off switch and smooth action rotating control
Just 1.75" x 1.75" inches square. 1/4" shaft with high quality knob
Screw down terminals for input and output wiring. Very easy to install.
Powerful enough to operate numerous panel lights and convenience lights
Just $29.95 (includes free domestic shipping !)
Pilot Light LED Light Strips are easy to install. Follow these simple steps:
To avoid possible damage, unroll and test fit when the temperture is above 60 degrees. Otherwise the Light Strip becomes somewhat more rigid.
Trimming: To trim to a desired length, use sissors or wire cutters. You can trim every 3 LEDs (2 1/2") without effecting the remaining LEDs.
Install: Apply double-sided 3M tape (included) to the reverse side of the strip, then apply the Light Strip to the underside of the glareshield. Avoid sharp bends.
Wiring: the white striped lead is the Positive (+) side. Unmarked is Ground (-). Connect to your dimmer or lighting rheostat.
>