LED Light Strips with Light Channel - High Output - Directional LED - 12VDC or 24VDC

NEW ITEM FOR 2020 

This high output LED strip is encased in a flexible silicone case that helps direct lighting to where it's needed.

Perfect for installations under a glareshield where lighting needs to be directed DOWNWARD onto the instrument panel

High power 3528 LEDs (120 per meter) provide bright LED lighting

Power leads at both ends for flexible wiring or for linking multiple segments together

Fully dimmable using PWM (or rheostat dimmers with some performance limitations)

Available in 12V and 24V versions.  Red, Blue or White LEDs.  Black silicone channel with opaque face for good lighting distribution

End caps provided for a clean installation

Specifications:

- 1 meter (39.4") length

- 120 LEDs per meter (the most available per meter).  3528-type LEDs.  

- 12 Volt or 24 Volt (please specify when ordering).  Low power consumption:  0.20A at max output

- Dimmable (see our PWM dimmers).  Note:  high-power LED strips are controlled best by PWM dimmers.  Simple rheostats provide limited dimming.

- Easy to trim (every 1.5").  

- Just 12mm in width. 5mm in height

- Supplied with 1' of color coded 22 AWG wire on one end.

- High-temperature 3M tape applied to reverse side for easy install

- Color options:  Cool White (5500K), Red, Blue

- Easily trimmable (see images) or linkable to additional segments or other lighting

SKU:  LED Strip-Light Channel Series

Packaging note:  ships on a 8" reel.  Lay flat to remove curve before installation. 

For installation: 

3M tape on reverse side is extremely strong. 

Clean the installation area and allow to dry.  Test and mark your installation area before removing the tapes protective cover.  Once in place it is difficult to remove the 3M tape.  Avoid sharp bends - the LED strip may be damaged.  

To trim, remove both end caps (wires run through these caps) and gently pull the strip out.  Trim at the "scissor" icons that appear about every 1.5".  Trim an equal amount from the light channel and then replace the strip into the light channel.  Replace the end caps.

Some installation locations may need additional adhesive.  Use 3M weatherstripping adhesive or similar strong glues.  (See attached image)